Automatic Start Up for Remote Control

When remote controls are not in use, the tilt sensor inside remote control keeps at OFF signal, remote controls are in sleep mode.  When users pick up the remote controls, tilt sensor provides ON signal and remote controls will be turned on automatically.  The batteries will last longer by install tilt sensor on remote controls.


  Recommend Model

OncQue RBS020902 SMD Tilt Sensor Switch

  • Horizontal tilt detecting
  • Operating Angle<20°
  • Process: SMD
  • Horizontal PCB
  • Dimension: Ø3*7.8

OncQue RBS200112 20°Tilt detecting for 4 direction Sensor Switch

  • 20°Tilt Detecting for 4 directions
  • DIP Normal Open
  • Installed above or under PCB
  • Dimension: 9.58*4.5*4.5 mm

OncQue RBS170200 SMD Under PCB One Axis 15° Tilt Sensor Switch

  • One Axis 15° Tilt detecting
  • Process: SMD
  • Horizontal Under PCB
  • Dimension: 5*6*5 mm


OncQue VBS030600 Omni-directional Vibration Sensor Switch


  • Omni-directional Vibration Detecting
  • Process: SMD
  • Both Suitable for horizontal and vertical PCB
  • Dimension: Ø4*7.5 mm